Installation guide

3-4 Compaq ProLiant ML350 Setup and Installation Guide

For use with 1-GHz or greater Intel Pentium III processor-based server models only

Compaq Confidential – Need to Know Required

Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:

Part Number: 201345-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 7/24/00 9:23 AM

3. Open the bezel fully to the right.

4. Loosen the two thumbscrews located on the left side of the front

chassis.

5. Slide the access panel back about 1.5 cm (0.5 in).

6. Lift and remove the panel.

7. Turn the access panel over to locate the System Configuration Label.

This label provides information on installing processor board options,

configuring drives, installing drives, and setting switches.

Figure 3-3. Loosening the thumbscrews and removing the access panel

To replace the access panel, reverse the above procedure.