Installation guide

Hardware Options Installation 3-3
For use with 1-GHz or greater Intel Pentium III processor-based server models only
Compaq Confidential – Need to Know Required
Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:
Part Number: 201345-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 7/24/00 9:23 AM
4. To remove the bezel, lift the bezel upward, and pull it away from the
chassis.
Figure 3-2. Removing the bezel
To replace the bezel, reverse the above procedure.
NOTE: When replacing the bezel, be sure the bottom hinge points are properly placed in
the chassis before rotating the bezel back into its original position.
Removing the Access Panel
To remove the access panel:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching.
CAUTION: Before removing the access panel, make sure that the server is
powered down, all cables are disconnected from the back of the server, and the
power cord is disconnected from the grounded (earthed) AC outlet.
CAUTION: Do not operate the server with the large access panel removed. This
panel is an integral part of the cooling system and removing it while the system
is running may adversely affect data integrity.
1. Follow the steps in “Powering Down the Server” at the beginning of this
chapter.
2. If necessary, unlock the bezel door.