Installation guide

3-2 Compaq ProLiant ML350 Setup and Installation Guide

For use with 1-GHz or greater Intel Pentium III processor-based server models only

Compaq Confidential – Need to Know Required

Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:

Part Number: 201345-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 7/24/00 9:23 AM

WARNING: To reduce the risk of injury from electric shock or damage to the

equipment when installing an upgrade, make sure that the server is powered

down. Remove all AC power cords to completely disconnect power from the

system.

5. Disconnect any other external equipment connections to the server.

Opening or Removing the Bezel

CAUTION: Before removing the bezel, make sure that the server is powered

down, all cables are disconnected from the back of the server, and the power

cord is disconnected from the grounded (earthed) AC outlet.

1. Follow the steps in “Powering Down the Server” at the beginning of this

chapter.

2. If necessary, unlock the bezel using the included key .

3. Open the bezel fully to the right.

Figure 3-1. Unlocking the keylock and opening the bezel