Installation guide

For use with 1-GHz or greater Intel Pentium III processor-based server models only
Compaq Confidential – Need to Know Required
Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:
Part Number: 201345-001 File Name: i-appc Switches and Jumpers.doc Last Saved On: 7/11/00 10:16 AM
Appendix C
Switches and Jumpers
When you add or remove a component or change a security feature, you must
reconfigure the server to recognize these changes. If the system configuration
is incorrect, your server may not properly work and you may receive error
messages on the screen. Setting the system board switches is part of the
reconfiguration process, along with running RBSU.
Setting System Board Switches
The ProLiant ML350 system board has a four-position switch (SW1) that is
used to set configuration settings on your server. For information on settings,
refer to the access panel labels, to the Compaq ProLiant ML350
Quick Start Poster, or to Table C-1 and Table C-2.