Installation guide

Regulatory Compliance Notices A-7
For use with 1-GHz or greater Intel Pentium III processor-based server models only
Compaq Confidential – Need to Know Required
Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:
Part Number: 201345-001 File Name: g-appa Regulatory Compliance Notices.doc Last Saved On: 7/11/00 9:10 AM
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and
Drug Administration implemented regulations for laser products on
August 2, 1976. These regulations apply to laser products manufactured from
August 1, 1976. Compliance is mandatory for products marketed in the
United States.
This marking on the internal
CD-ROM drive indicates that the
product is classified as a
CLASS 1 LASER PRODUCT.
Power Cords
If you were not provided with a power cord for your computer, you should
purchase a power cord that is approved for use in your country.
The power cord must be rated for the product and for the voltage and current
marked on the product electrical ratings label. The voltage and current rating
of the cord should be greater than the voltage and current rating marked on the
product. In addition, the diameter of the wire must be a minimum of 1.00 mm²
or 18AWG, and the length of the cord must be between 1.8 m (6 ft) and 3.6 m
(12 ft). If you have questions about the type of power cord to use, contact your
Compaq authorized service provider.
A power cord should be routed so that it is not likely to be walked on or
pinched by items placed upon it or against it. Particular attention should be
paid to the plug, electrical outlet, and the point where the cord exits from the
product.
Mouse Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.