User guide

Hardware options installation 68
CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that you
are properly grounded (earthed) before beginning any installation procedure.
To install the component:
1. Identify the redundant power supply bay ("Rear panel components" on page 9).
IMPORTANT: Power supplies for the model shown are hot-pluggable. When using the
redundant power supply option, it is not necessary to power down the server before removing
or installing a power supply.
2. Remove the power supply blank.
WARNING: To reduce the risk of electric shock or damage to the equipment, do not connect
AC power cords to uninstalled power supplies.
3. Slide the power supply into the power supply bay until the release/lock lever clicks, securing the
power supply.
4. Connect the power cord to the power supply.
5. Using the retaining clip shipped with the server, secure the power cord to the power supply handle.
Securing the cord will ensure enough slack.