Specifications

2-30 Compaq ProLiant DL760 Servers Maintenance and Service Guide
To remove a DIMM:
1. Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2. Remove the Processor and Memory Module. See “Opening and Removing the Processor
and Memory Module” earlier in this chapter.
3. Remove the memory board. See “Removing the Memory Board” earlier in this chapter.
4. Press outward on the socket latches at each end of the DIMM .
5. Remove the DIMM from the memory expansion board .
1
1
2
Figure 2-24. Removing a DIMM from the memory board
Reverse steps 1 through 5 to replace a DIMM.
CAUTION: The ejectors prevent the memory expansion board from lying completely flat.
Inserting a DIMM without counter pressure applied behind the socket to the back of the
expansion board can cause the memory expansion board to flex and could result in damage.
Always support the memory expansion board or apply counter pressure while inserting a DIMM.
IMPORTANT: Make sure that both latches are secured when the DIMM is installed.