Specifications

Removal and Replacement Procedures 2-23
8. Remove the power switch plate from the media module .
3
Figure 2-17. Removing the power switch plate from the media module
9. Squeeze the grommets around the LEDs, and remove the LEDs from the grommets.
Remove the thermistor from the bracket assembly
.
10. Pull the switch assembly out of the power switch plate .
4
4
5
Figure 2-18. Removing the Power On/Standby switch from the power switch plate
Reverse steps 1 through 8 to replace the Power On/Standby switch assembly.
NOTE: The Power On/Standby switch LED is in the top position, and the thermistor is in the bottom
position.