Specifications

Chapter 2
Removal and Replacement Procedures
This chapter provides subassembly/module-level removal and replacement procedures for
Compaq ProLiant DL760 servers. After completing all necessary removal and replacement
procedures, run the Diagnostics program to verify that all components operate properly.
To service Compaq ProLiant DL760 servers, you might need the following:
■ Flat-blade screwdriver (four millimeter)
■ Torx T-15 screwdriver
■ Phillips screwdriver
■ From the Compaq SmartStart™ for Servers CD:
G ROM-Based Setup Utility (RBSU) software
NOTE: For more information on RBSU, refer to the ROM-Based Setup Utility User Guide.
G Drive Array Advanced Diagnostics software (DAAD)
G Array Diagnostics Utility software (ADU)