Specifications

Component identification 87

*The server ships with one PCIe3 riser cage installed in the primary riser cage connector.

†PCIe slot 3 is connected to the southbridge and runs at the Gen2 signaling rate.

Notes:

• "Primary" denotes the riser cage is installed in the primary riser connector.

• "Secondary" denotes the riser cage is installed in the secondary riser connector.

• Installing the riser cages listed in the table above in either the primary or secondary riser connectors

determines the form factor of the PCI cards supported by those riser cages.

• FL/FH denotes full-length, full-height. HL/FH denotes half-length, full-height. LP denotes low profile.

• The PCIe2 x16 riser cage supports a maximum power of 150 W with an HP power cable. This cable

must be used for PCIe card wattages greater than 75 W.

System board components

Item Description

Fan connector 6