Specifications

Removal and replacement procedures 61
IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.
To remove the processor:
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend ("Extend the server from the rack" on page 28) or remove ("Remove the server from the rack" on
page 29) the server from the rack.
4. Remove the access panel ("Access panel" on page 33).
5. Remove the air baffle ("Air baffle" on page 34).
6. Remove the heatsink ("Heatsink" on page 58).
7. Open each of the processor locking levers in the order indicated, and then open the processor retaining
bracket.