Specifications

Removal and replacement procedures 40
3.
Remove the drive.
To replace the component, reverse the removal procedure.
Power supply blank
Remove the blank.
To replace the component, reverse the removal procedure.
AC power supply
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Access the product rear panel (on page 30).
4. Remove the power supply.