Specifications

Removal and replacement procedures 38
8.
Remove the secondary PCIe riser cage.
To replace the component, reverse the removal procedure.
PCIe riser board
To remove the component:
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend ("Extend the server from the rack" on page 28) or remove ("Remove the server from the rack" on
page 29) the server from the rack.
4. Remove the access panel ("Access panel" on page 33).
5. If any full-length expansion boards are installed, release the full-length expansion board retainer (on
page 31).
6. Remove the PCIe riser cage ("PCIe riser cage (primary)" on page 36).
7. Remove any expansion boards from the PCIe riser cage ("Expansion boards" on page 56).