Specifications

Removal and replacement procedures 48
7.
Remove the DIMM.
To replace the component, reverse the removal procedure.
Heatsink blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 30).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 31).
o Remove the server from the rack (on page 33).
4. Remove the access panel ("Access panel" on page 36).