User's Manual
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures
- Setup Utility
- Specifications
- Computer specifications
- 15.4-inch, WXGA, BrightView display specifications
- Hard drive specifications
- DVD±RW and CD-RW SuperMulti Double-Layer Combo Drive specifications
- HD DVD-ROM Drive with SuperMulti DVD±R/RW Double Layer support specifications
- Blu-ray Disc ROM Drive with SuperMulti DVD±R/RW Double-Layer (DL) support specifications
- System DMA specifications, Intel
- System DMA specifications, AMD
- System interrupt specifications, Intel
- System interrupt specifications, AMD
- System I/O address specifications, Intel
- System I/O address specifications, AMD
- System memory map specifications, Intel
- System memory map specifications, AMD
- Screw listing
- Phillips PM2.0×5.0 captive screw
- Phillips PM3.0×3.0 screw
- Phillips PM2.0×3.0 screw
- Phillips PM2.5×7.0 screw
- Phillips PM2.5×10.0 screw
- Phillips PM2.5×4.0 screw
- Phillips PM2.5×3.0 screw
- Hex HM5.0×9.0 standoff
- Phillips PM2.0×2.0 screw
- Phillips PM2.0×7.0 screw
- Phillips PM2.5×5.0 captive screw
- Phillips 2.5×4.0 captive screw
- Backup and recovery
- Connector pin assignments
- Power cord set requirements
- Recycling
- Index
16. Remove the display hinges (2). The display hinges are available using spare part number
433288-001.
17.
If it is necessary to replace the wireless antenna transceivers and cables, remove the Phillips
PM2.0×3.0 screw (1) that secures each transceiver to the display enclosure.
18. Release the retention tabs (2) built into the display enclosure that secure the wireless antenna cables
and remove the cables from the tabs.
19. Detach the wireless antenna transceivers (3) from the display enclosure. The wireless antenna
transceivers and cables are available using spare part numbers 449728-001 (for use only with
computer models equipped with an 802.11a/b/g/n WLAN module) and 449726-001 (for use only
with computer models equipped with an 802.11a/b/g or 802.11b/g WLAN module).
20.
Remove the wireless antenna transceivers and cables.
21. If it is necessary to replace the microphones and cables, release the retention tabs (1) built into the
display enclosure that secure the microphone cables to the display enclosure.
22. Remove the microphone receivers (2) from the clips in the display enclosure.
62 Chapter 4 Removal and replacement procedures