- Hewlett-Packard Notebook PC Hardware Guide
Table Of Contents
- Contents
- Hardware
- TouchPad and Keyboard
- Power
- Power Sources
- Power Control and Light Locations
- Standby, Hibernation and Shutdown Overviews
- Standby, Hibernation and Shutdown Procedures
- Power Preferences
- Battery Pack
- Disposing of a Used Battery Pack
- Multimedia
- Wireless (Select Models Only)
- Security
- Hardware Upgrades and Replacements
- Software Updates and Recoveries and System Software
- Specifications
- Index
Multimedia
Hardware and Software Guide 4–13
Installing Software
To install software included with the notebook from a CD:
1. Insert an appropriate optical drive into the notebook
MultiBay II as instructed in the
“Inserting or Removing a
Disc” in this chapter.
2. Connect the notebook to a reliable electrical outlet.
3. Close any open applications.
4. Insert a software CD into the optical drive.
❏ If Autorun is enabled an installation wizard is displayed.
❏ If Autorun is disabled, select Start > Run. Enter:
x:\setup.exe
(where x is your CD drive designation), and then
select
OK.
5. When the installation wizard is displayed, follow the
installation instructions on the screen.
6. Restart the notebook if prompted.
✎
Repeat the installation procedure for all software you want to
install.
✎
WinDVD Creator has special drive requirements for proper
installation. To install WinDVD Creator, refer to the
instructions provided with the InterVideo WinDVD
Creator CD.