User`s guide

3 Basic Procedures
3-6
9 From the File menu, click Save As. The Save As dialog box opens. In the
File name text box, enter a filename for your Simulink model and click
Save. For example, type
rtwin_model
Simulink saves your model in the file rtwin_model.mdl.
To specify a default Real-Time Windows Target configuration set for your
model, see “Specifying a Default Real-Time Windows Target Configuration
Set” on page 3-13. If you activate this configuration set for your model, you can
build your real-time application later without setting additional configuration
parameters.
To manually configure your model, continue to “Entering Configuration
Parameters for Simulink”, following. That section teaches you how to enter
configuration parameters for your Simulink model, then leads you into
procedures for entering scope parameters and running a non-real-time
simulation of the model.
Entering Configuration Parameters for Simulink
The configuration parameters give information to Simulink for running a
simulation.
After you create a Simulink model, you can enter the configuration parameters
for Simulink. This procedure uses the Simulink model
rtwin_model.mdl as an
example and assumes you have already loaded that model: