User`s guide

I/O Driver Blocks
4-19
If you chose Bit, your dialog box will look similar to the figure shown below.
7 Do one of the following:
- Click
Apply to apply the changes to your model and leave the dialog box
open.
- Click
OK to apply the changes to your model and close the Block
Parameters: Digital Output
dialog box.
Counter Input Block
This Real-Time Windows Target I/O block allows you to select and connect
specific counter input channels to your Simulink model.
After you have added a Counter Input block to your Simulink model, you can
enter the parameters for this I/O driver. This procedure uses Humusoft’s
MF604 I/O board as an example: