User`s guide

4 Advanced Procedures
4-16
4 From the Channel mode list, choose one of the following options:
-
Bit — Returns a value of 0 or 1.
-
Byte — Groups eight digital lines into one digital channel and returns a
value of 0 to 255.
If you chose
Bit, your dialog box will look similar to the figure shown below.
5 Do one of the following:
- Click
Apply to apply the changes to your model and leave the dialog box
open.
- Click
OK to apply the changes to your model and close the Block
Parameters: Digital Input
dialog box.
Digital Output Block
The Real-Time Windows Target I/O blocks allow you to select and connect
specific digital lines or digital channels to your Simulink model.