User`s guide

4 Advanced Procedures
4-14
7 Enter a final value for each analog channel you entered in the Output
channels
box. For example, if you entered [1,2] in the Output channels
box, and you want final values of 0 volts, enter
[0,0].
If you chose
Volts, your dialog box will look similar to the figure shown
below.
8 Do one of the following:
- Click
Apply to apply the changes to your model and leave the dialog box
open.
- Click
OK to apply the changes to your model and close the Block
Parameters: Analog Output
dialog box.