User`s guide

I/O Driver Blocks
4-9
2 Click and drag the Analog Input block to your Simulink model. Remove the
Signal Generator block and connect the Analog Input block to the Transfer
Function block.
Your Simulink model will look similar to the following figure.
You next task is to enter parameters for the Analog Input block. See “Analog
Input Block” on page 4-10.
Simulink Library
This topic describes how to access the Real-time Windows Target library from
the Simulink window. The Real-Time Windows Target I/O driver blocks allow
you to select and connect specific analog channels and digital lines to your
Simulink model through I/O driver blocks.
After you create a Simulink model, you can add an I/O block. This procedure
adds and Analog Input block and uses the Simulink model
rtwin_model.mdl
as an example:
1 In the Simulink window, and from the View menu, click Library Browser.
The Simulink Library Browser opens.