User`s guide

4 Advanced Procedures
4-4
4 Click the Test button.
The Real-Time Windows Target tries to connect to the selected board, and if
successful, displays the following message.
5 On the message box, click OK, and then on the I/O board dialog box, click OK
again.
The I/O driver
Block Parameters dialog box closes, and the parameter
values are saved with your Simulink model.
The I/O board information is included with each I/O driver block. You only
install and enter the board information once with the first I/O driver block you
add to your model. When you add another I/O driver block, choose the I/O board
from the list of installed boards. You do not need to enter any board
information.
ISA Bus Board
Most ISA bus I/O boards are preset with a base address of 0x300. If you are
using multiple I/O boards or other boards (for example, network cards) that
already use the address
0x300, you must set your board with another base
address.
In the I/O board dialog box, enter the same base address that you set on the
physical board. You open the I/O board dialog box from any I/O driver
Block
Parameters
dialog box.