User`s guide

English
27
Troubleshooting a wireless connection
During software installation
During the software installation process, the setup wizard searches for the printer
twice, once when the Ethernet cable is connected to the printer, and then after the
Ethernet cable has been removed.
The computer cannot find the printer when the Ethernet cable
is connected
If the computer cannot find the printer when the Ethernet cable is connected, verify the
following before investigating any of the topics in this section:
• All cable connections to the computer and the printer are secure.
• The network is operational and the network hub, switch, router, or Wireless
Access Point (WAP) is powered on.
• The printer is powered on, paper is loaded in the In tray, and the print
cartridges are correctly installed.
• All applications, including virus protection programs and personal firewalls,
are closed or disabled.
If you corrected any of the above, try running the installation wizard again.
Connect the Ethernet cable if it is not connected
Connecting the Ethernet cable to the printer is crucial to successfully configuring the
printer to operate on a wireless network.
Use an Ethernet cable to connect the printer to an Ethernet port on the network, such
as an available Ethernet port on a Wireless Access Point (WAP), router, hub, or wall
socket.
After connecting the cable, rerun the installation wizard. When prompted during the
installation, remove the Ethernet cable.
Marlin_NG.book Page 27 Friday, June 18, 2004 2:54 PM