Product manual

R
2800 LAURA LANE • MIDDLETON, WI 53562 • [phone] • FAX [phone] • www.tcsbasys.com
8
give the controller from the other drop down menu. If
the current address is not known, select the desired
adddress from the drop down menu. When finished
press the submit button at the bottom of the Controller
Addressing page.
Ubiquity Systems Software
The Ubiquity system addresses the market’s desire
for a fully integrated system in a single, customizable
package. Ubiquity can function as an embedded
application in the QD2040 or as a centrally hosted
application that readily and easily interfaces with
a QD2040. The system is designed on a modular
approach to collect and manage information and data.
This strategy provides us the opportunity to effectively
package a solution tailored to embrace your most
immediate concerns. Plus our advanced controls and
monitors, combined with this easily modified modular
approach, offers the scalability to effectively meet your
future demands.
The Ubiquity systems modular design incorporates:
• Energy and environmental managment
• TCS Basys Controls energy management system
• Automated lighting management
• Refrigeration and freezer monitoring and alarming
• Global scheduling, programming and alarming
• Integrated preventive and reactive maintenance
functions
Refer to the Ubiquity Manual for further information
Checkout & Troubleshooting
CHECKOUT
1. Be sure to check and verify all wiring before
powering the QD2040.
2. Apply power. The QD2040 Power LED will turn on.
3. The Processing LED will begin blinking indicating that
the device is running.
4. If the QD2040 has not been pre-programmed, it can
be programmed at this time.
5. The QD2040 is now ready for operation.
Rev:0409
C3597_REV3
TROUBLESHOOTING
Power LED does not light up
Be sure that the power supply module, included with the
QD2040, is plugged in to an outlet that has power.
No Communications with Controllers on the network
Make sure the baud rate selection for the QD2040 is
set to match the baud rate of all the controllers on each
port network. All controllers on the network must have
a unique address, excluding the address ‘248’. Network
wiring should also be checked.
LED Description
Three LEDs on the unit allow the occupant to view the
current operating status of the QD2040.
Power
This LED will be on when the QD2040 is properly
powered.
Processing
This LED flickers rapidly when the QD2040 is processing
information.
LAN
The LED on the LAN 10/100 card notes activity on the
ethernet. A blinking light represents communications.