Technical data

Installing TCP/IP Services
2.3 Postinstallation Tasks
1. Optionally, you can:
– Read the Compaq TCP/IP Services for OpenVMS Release Notes on line or
print the file from SYS$HELP:TCPIP053_RELEASE_NOTES.PS or
SYS$HELP:TCPIP053.RELEASE_NOTES.
– Display a list of the TCP/IP Services files that were installed. Enter the
following command:
$ PRODUCT LIST TCPIP /SOURCE=directory-path
In this command, directory-path specifies the disk and directory name
for the source drive that holds the TCP/IP Services kit (for example,
/SOURCE=DKA400:[TCPIPAXP053]). If you do not specify the source
qualifier, the POLYCENTER Software Installation utility searches the
location defined by the logical name PCSI$SOURCE. If not defined, the
utility searches the current default directory.
2. If you had a previous version of TCP/IP Services configured on your system
and the software was previously started, reboot your system for the new
TCP/IP Services software to take effect. Proceed to step 4.
Important
Do not delete any files that remain from the previous version of the
product. Many of these files are used by TCPIP$CONFIG for converting
your existing configuration to the new configuration (described in
Chapter 3).
3. Log out of the SYSTEM account, and then log back in to the SYSTEM account
to establish the TCPIP command environment.
4. Proceed to Chapter 3 to configure TCP/IP Services.
2–4 Installing TCP/IP Services