User guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-5
Netelligent 1108 100Base-TX Repeater User Guide
Writer: Chris Seiter Project: Installing the Hub Comments: 185813-002/707085-001
File Name:MIC100_3.DOC Last Saved On:3/13/96 11:19 AM
PWR
MDIMDI-X
ACT
COL
UPLINK
12 34 5 6 7 8
XXXXXXX
MDIMDI-X
UPLINK
UPLINK Switch
Set to MDI Position
PWR
MDIMDI-X
ACT
COL
UPLINK
12 34 5 6 7 8
XXXXXXX
Figure 3-5. Interconnecting 100Base-TX Repeaters (Set to MDI Position)
Connecting Power
Follow these steps to connect the repeater to power:
WARNING: The repeater has no power switch. Plugging in the power
cord powers up the repeater.
1. Plug the power cord into the power connector on the back of the
repeater.
2. Insert the three-pronged plug on the power cord into a non-switched,
grounded power outlet on a wall, a power strip, or a grounded
extension cord.
NOTE: The power outlet should be near the repeater and easily accessible.