User guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-2 Installing the Hub
Writer: Chris Seiter Project: Installing the Hub Comments: 185813-002/707085-001
File Name:MIC100_3.DOC Last Saved On:3/13/96 11:19 AM
Figure 3-1. Attaching the Mounting Brackets
After you attach both mounting brackets, position the bracket slots over the
desired holes on the rack (Figure 3-2). Then insert and tighten the mounting
screws (not supplied).
PWR
MDIMDI-X
ACT
COL
UPLINK
12 34 5 6 78
XXXXXXX
Figure 3-2. Positioning the Repeater in a Rack
Connecting Twisted-Pair Cable
Each RJ-45 port on the repeater can accept a standard 4-wire twisted-pair
(UTP or STP) cable that ends with an RJ-45 connector. These ports can
support cable lengths up to 100 meters (328 feet).
To attach twisted-pair cable, plug one of the RJ-45 connectors into the
selected port on the repeater. Connect the other RJ-45 connector into a
100Base-TX-equipped workstation.