User guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-8 Setting Up the Repeater
Writer: Liz Fischer Project: Setting Up the Repeater Comments: 268749-001
File Name:749_3.doc Last Saved On:6/25/96 9:30 AM
Repeater-to-Workstation Connection
To connect the repeater to a workstation, follow these steps:
1. Plug one end of the modular cord into a 10Base-T-equipped
workstation.
2. Plug the other end of the modular cord directly into the desired port on
the repeater, as shown in Figure 3-5. The maximum end-to-end cable
distance is 328 feet (100 meters).
10Base-T-Equipped
Workstation
PWR
ACT
COL
MEP
1
X
9
2
10
3
11
4 12
5
13
6 14 7
15 8 16
UPLINK
MDI MDI-X
Media Expansion Port
Figure 3-5.
Repeater-to-Workstation Connection
After you connect the workstation to the repeater and power on both units, the
repeater's PWR LED and the LED that corresponds to the connected port
should be ON. If the LEDs are OFF, verify that the connections are correct.