User guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-1
Compaq Netelligent 1009B 10Base-T Hub User Guide
Writer:
Chris Seiter
Project:
Installing the Hub
Comments:
File Name:
1009B_3.DOC
Last Saved On:
5/19/97 3:24 PM
Chapter 3
Installing the Hub
This chapter describes how to install the Netelligent 1009B 10Base-T Hub. It
describes specific installation requirements, installation procedures, and basic
network connections.
Site Requirements
Consider the following site requirements before you install the hub.
Q
Verify that the power source meets the following electrical
specifications.
AC Power Frequency
100 to 240V (+/- 10%) 50 to 60Hz (+/- 3Hz)
Q
Be sure the adapter supplied with your hub matches your site’s utility
voltage.
Q
Leave at least 10 cm. of space at the front and back of the hub for
ventilation. We recommend that you install the hub in a cool, dry area.
Q
Be sure you place the hub on a solid, level surface, such as a table or
shelf. A good location is at the center of all the devices you want to link,
close to the trunk segment, and near a power outlet.
Q
Be sure you connect the hub only to another 1009B or compatible
10Base-T hub.