User`s guide

ManualsBrandsCompaq ManualsSwitchNetelligent 1005

100

Installation 3-39

Compaq Confidential – Need to Know Required

Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:

Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM

4. To select a configuration option, press the or button on the control

panel until the

on the display is next to the option you want to

change. In this case, let us choose Set SCSI. Press the

Enter

button to

display the choices for that option. The submenu in Figure 3-28 appears:

Library Parity:

*Enabled

Library Bus ID:

Figure 3-28. Set SCSI Submenu

NOTE: Take a moment to look closely at the submenu in Figure 3-28. Note that the

the display is next to line 1,

and

that line 2 is indented. This tells you that Figure 3-28 is a

two-tiered menu

. The and buttons work on two levels in this kind of menu, which

is typical of many submenus of the Configure Menu. The first level is as follows: If you

press the

button, the moves to line 3. If you press the button, the moves

back to line 1.

If you press the Enter button while the

is next to line 1 (or line 3), the and

buttons operate on the second level. You can tell because the moves next to line 2 (or

line 4), and a

appears at the end of line 4, indicating that there is a list of settings that

can be scrolled using the

and buttons.

The

at the end of line 4 means that there are other items that can be displayed by

scrolling, using the

button repeatedly.

5. Note that the Library SCSI ID is set to 0. Suppose you want to set the

DLT0 bus ID to 3. With the

next to line 1, press the button

repeatedly until the display scrolls as shown in Figure 3-29:

DLT0 Bus ID:

DLT1 Bus ID:

Figure 3-29. Set SCSI Submenu Scrolled

6. With the next to line 1, press the

Enter

button. The moves to line

2 and the

remains at the end of line 4, and a appears at the end of

line 1. Now you can use the

and buttons to scroll through the

possible settings. Scroll downward so that 3 is displayed, then press the

Enter

button to save the new selection. An * appears to the left of the 4,

to indicate that it is the current selection.