User`s guide

Installation 3-25
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM
b. Using mounting screws (P/N 213164-108), mount the slide bracket
assembly using the two mounting holes marked 2, 3, 4, 5 or 6 to
mount the second, third, fourth, fifth, or sixth module respectively.
Start by mounting the slide/bracket assembly to the rear of the
StorageWorks cabinet. Hold the bracket/slide assembly in place with
one hand, fasten the mounting screw to the bracket holes marked
with a number that corresponds to the module number.
c. Be careful to mount all four brackets at the same height. You can use
a ruler or count the hole numbers to achieve this.
d. Tighten all four corners and the slide extension.
You are now ready to install the pass-through mechanism in the rack as
described in the section entitled Installing the Pass-Through Mechanism in the
Rack.