User`s guide

Installation 3-21
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM
7. Slide the module in and out several times, ensuring that the inner and
outer slide locks engage, and that the module does not bind against the
slides.
8. If binding occurs, loosen the four screws that secure the slides to the
front rails and the four screws that secure the slides to the rear rails.
9. If necessary, repeat steps 8 and 9 until the module does not bind against
the slides.
10. If the rails on your rack are not threaded, install a clip nut on each front
rail at the height of the captive screws on the front panel of the Base
Module. If the rails on your rack are threaded, skip this step.
11. Slide the Base Module into the rack, and tighten the captive screws.
12. Once you have securely installed the MiniLibrary into the standard rack,
proceed to the section entitled Interfaces and Cabling.