User`s guide

Installation 3-19
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM
Rackmounting in a Standard 19” EIA/RETMA
Cabinet:
These procedures assume that you have already separated the slide racks and
attached the mounting brackets to the slides as described in the beginning of
this chapter. Next:
1. Fasten each outer slide behind the front rail of the rack using two 10-32
low-profile screws with washers and one nut plate. Two 10-32 clip nuts
are provided to engage the captive screws on the front panel.
2. Fasten each of the mounting brackets to the front of the rear rail of the
rack using two 10-32 screws and one nut plate.
3. Tighten the screws installed in step 4 of the previous section.
4. If they are not already locked, pull the intermediate slides toward the
front (out of the rack) so that they lock in the extended position.