User`s guide

Installation 3-15
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM
NOTE: Figure 3-9 omits the door on the car for clarity.
Do not remove the door
.
15. To steady the belt block, grasp the belt several inches from the block
and push toward the back of the track until the block is pressed firmly
against the back of the track. While holding the belt with one hand,
compress the springs and swing the car downward until the remaining
wheels are aligned with their groove in the track.
16. While continuing to press the belt block against the back of the track,
release the car so that the stationary wheels engage their groove in the
track.
17. While continuing to press the belt block against the back of the track,
begin to tighten the captive screws. When both screws are partially
threaded into the belt block, release the belt and finish tightening the
screws. Be sure that the block is fully seated against the bracket on the
car. Close and secure the door on the car.
18. Using nylon button rivets, install covers over any exposed pass-through
mechanism sections that are not covered by modules.
NOTE: See Appendix G,
Additional Information on Pass-Through Section Covers.
19.
Proceed to the section entitled Mechanical Installation of the Expansion
and Base Modules.
Adding to an Existing Pass-Through Mechanism
Before reading this section, it may be helpful to familiarize yourself with the
parts and procedures by reading the two preceding sections. To add to an
existing pass-through mechanism, you must first partly disassemble it, then
make the necessary changes as described in the preceding sections. Use the
following procedure for disassembly.
1. Locate the covers over the drive motor section and the base assembly. Note that the
covers are held in place by nylon button rivet fasteners. Using a suitable thin-bladed
tool, pry up the cover until the fasteners can be removed. Set the covers aside, and save
the fasteners for re-use.
2. Place the pass-through mechanism on a suitable work surface with the motor at the left
and pointed upward. Referring to Figure 3-9, open the door of the car to gain access to
the captive screws. Do not remove the door. Loosen the captive screws until they are
disengaged from the belt block.
3. Grasp the closed side of the car and pull it toward you so as to compress the springs
underneath the car. When the wheels on the closed side are clear of the track, lift the
car from the track and set it aside.