User`s guide

3-12 TL891 MiniLibrary System User's Guide
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM
4. Refer to Table 3-1 for the required belt length for your system. After
double-checking the length specified, cut the belt between teeth.
5. With the toothed side of the belt toward you, position the right end of
the belt about halfway along the pass-through mechanism.
6. Referring to Figure 3-5, thread the left end of the belt counter-clockwise
around the motor drive pulley.
7. Referring to Figure 3-6, thread the belt from the motor drive counter-
clockwise around the idler pulley and back to the right end.
8. Holding the ends of the belt as shown in Figure 3-7, the two ends should
be touching or very slightly overlapping.
SHR-1238
Figure 3-6. Threading the Belt through the Base Section