User`s guide

3-10 TL891 MiniLibrary System User's Guide
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM
Place pairs of tie bars so that they straddle all of the joints where sections
come together. Be sure that the beveled edge is toward the inside corner of the
sections.
5. Install two M3 x 20 mm Phillips sems screws through each tie bar into
the threaded holes in the flanges of the extrusion sections. Tighten
finger tight only. Insert two M3 x 20 mm sems screws through each tie
bar into the side of the extrusion sections and finger tighten.
6. Firmly press the neighboring sections together while tightening the two
M3 x 20 mm screws through each tie bar into the flanges of the sections.
Alternately tighten the screws into the flanges and those into the sides of
the extrusions to ensure that each tie bar is drawn into the corner of the
extrusion.
IMPORTANT: Be careful not to overtighten these screws.
7. Inspect the joint to see that the sections are well aligned, with minimal
irregularities and gaps.
8. Repeat steps 6, 7, and 8 for each pair of sections. It may be necessary to
use suitable blocks to support the row of sections so that neither the
motor housing nor the bottom flange of the base section touches the
work surface while you are connecting the motor drive section.
9. Center one of the support bars across the rear of the motor drive section
over the holes on the rear surface of that section.
10. Insert two M4 x 20 Phillips sems screws through the holes in the support
brace into the holes in the motor drive section, and tighten.
11. Go to the next section, Installing the Belt.
Installing the Belt
Refer to Figures 3-5 through 3-9.
1. Turn the assembled pass-through mechanism over so that the motor
points upward.
2. Referring to Figure 3-6, locate the tensioner ramp in the base section.
Compress the spring until the hole in the tensioner ramp is aligned with
a hole in the base section. Insert an 0.050” Allen wrench or a paper clip
through the holes. This sets the idler pulley for zero belt tension.
3. Locate the length of toothed belt that was enclosed with the extension
section.