User`s guide

F-8 TL891 MiniLibary System User's Guide
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibary System User's Guide Comments:
Part Number: ER-TL891-UA. A01 File Name: m-appf Addding a Second Tape Drive Last Saved On: 3/1/99 1:26 PM
3. Disconnect the RS-422 cable toward the front on the top of the drive,
and lift the cable clear of the cable clamps; set it aside.
4. Install the door lever on the flatted shaft at the bottom of the drive.
5. Slide the drive (6) into the drive caddy assembly; position the drive so
the threaded holes in the top and bottom of the drive are aligned with
the screws holes.
6. Install the four 6-32 sems pan-head Phillips screws that were removed
in Step 1.
7. Connect the unused connector on the power Y-cable to the drive just
installed.
8. Connect the unused connector on the SCSI cable to the drive just
installed.
9. Install the RS-422 cable supplied with the kit, sliding it under the
clamps so that the connector is adjacent to the connector on top of the
new drive.
10. Install the RS-422 cable removed in Step 3 over the top of the new RS-
422 cable so that the connector is adjacent to the connector on top of
the original drive.
11. Connect the RS-422 cables to the connectors on the top of the drives,
through the holes in the top of the drive caddy assembly.
12. Replace the drive caddy assembly as described in Removing and
Replacing the Drive Caddy Assembly.