Specifications
7-8
Compaq StorageWorks SAN Switch 16 Installation and Hardware Guide
Compaq Confidential – Need to Know Required
Writer: Hilary Stead Project: Compaq StorageWorks SAN Switch 16 Installation and Hardware Guide Comments:
Part Number: EK-BCP28-IA / 161356-001 File Name: H-CH7 REPAIR AND REPLACEMENT.DOC Last Saved On: 9/30/99 11:34 AM
Installing the Motherboard
1.
Align the motherboard assembly with the mounting screw on the bottom
of the switch chassis and slide the motherboard assembly into the
chassis.
2.
Turn the mounting screw on the front panel clockwise to fasten it.
Continue turning the screw until it no longer moves.
3.
Push the motherboard assembly into the chassis to be sure it is properly
seated.
4.
Reinstall the power supply or supplies. See “Installing the Power
Supply” earlier in this chapter.
5.
Reinstall the GBIC modules. See “Installing a GBIC Module” earlier in
this chapter.
6.
Reconnect all external cabling.
7.
Turn on the switch’s power supplies. The switch automatically runs
POST.
8.
Check for error messages through Telnet.
Replacing the Chassis
To replace the chassis assembly, you must remove the switch’s
GBIC modules, cover, motherboard, power supply or supplies, and fan
assembly from the current chassis, and install them into the new chassis
assembly.
Removing the Switch Components
To remove the switch components:
1.
Turn off the power to the switch.
2.
Remove all external cabling from the front panel.
3.
Remove the power supply or supplies. See “Removing the Power
Supply” earlier in this chapter.
4.
Remove all GBIC modules. See “Removing a GBIC Module” earlier in
this chapter.