Specifications

7-6
Compaq StorageWorks SAN Switch 16 Installation and Hardware Guide
Compaq Confidential – Need to Know Required
Writer: Hilary Stead Project: Compaq StorageWorks SAN Switch 16 Installation and Hardware Guide Comments:
Part Number: EK-BCP28-IA / 161356-001 File Name: H-CH7 REPAIR AND REPLACEMENT.DOC Last Saved On: 9/30/99 11:34 AM
Removing the Fan Assembly
To remove the fan assembly:
1. Unfasten the four captive screws on the rear of the switch.
2. Carefully pull the fan assembly out of the chassis rear panel.
Figure 7-4. Fan assembly
Installing the Fan Assembly
To install the fan assembly:
1. Slide the assembly into the back of the switch chassis.
NOTE:
Make sure that the fan’s connector is oriented properly. Do not force the
connector.
2. Fasten the four captive screws on the rear of the chassis.
Replacing the Motherboard
To replace the motherboard, remove the existing motherboard assembly, then
install the new motherboard assembly.
NOTE:
You need a #4 flat head screwdriver to remove and install a motherboard.