Specifications

Specifications
C-5
Compaq Confidential – Need to Know Required
Writer: Hilary Stead Project: Compaq StorageWorks SAN Switch 16 Installation and Hardware Guide Comments:
Part Number: EK-BCP28-IA / 161356-001 File Name: K-APPC SPECIFICATIONS.DOC Last Saved On: 9/30/99 11:36 AM
Power Supply
The SAN Switch 16 has a Universal Power Supply capable of functioning
worldwide without voltage jumpers or switches. The supply is autoranging in
terms of accommodating input voltages and line frequencies. The power
supply meets the requirements outlined in the following table.
Table C-6
Power Supply Requirements
Feature Requirement
Total power 150 watts
Input voltage 85 to 265 VAC
Input line frequency 47 to 63 Hz
Inrush current 10 amps peak > 300 usec - hot/cold start
Harmonic distortion Active power factor correction per IEC1000-3-2
Input line protection Fused in both hot and neutral lines
Maximum dimensions H: 1.5 in. (38.1 mm), W: 3.5 in. (88.9 mm), L: 11 in.
(279.4 mm)
Redundancy Dual power supplies - Hot-pluggable
The power supply plugs directly into the enclosure through the front panel,
mating to an internal blind-mate connector. The power supply supports a
dual-redundant power supply configuration in which the supplies are
hot-pluggable.
An integral on/off switch, input filter, and power indicator are provided in the
power supply.