Technical data

Table C–36: Printer Data Sheet: GENICOM mL450 PS (cont.)
xxx-ready attributes
document-formats-ready = PostScript simple-text
native-document-formats-ready = PostScript
input-trays-ready = main manual [ bottom large-capacity middle top 1 2 345]
output-bins-ready = top [ stacker-1 1 2 ]
media-ready = [ a a3 a4 b ledger letter tabloid ]
sides-ready = 1 [ 2 ]
finishings-ready = [ bind punch staple staple-bottom-left staple-dual-left
staple-top-left ]
Implementation notes
This printer supports an optional stapler, punch, and stacker finishing
unit. To enable these options set finishings-supported="staple
staple-top-left staple-bottom-left staple-dual-left
punch bind" on the logical and physical printers, and set
finishings-ready="staple staple-top-left staple-bottom-left
staple-dual-left punch bind" on the physical printer object.
To print a document with a finishing feature select one of the following options:
finishing=staple, Single staple the top edge of each document.
finishing=staple-top-left, Single staple the top edge of each document.
finishing=staple-bottom-left, Single
staple the bottom edge of each document.
finishing=staple-dual-left,Two
staples on the long-edge of each document.
finishing=punch, Three hole punch the long-edge of each document.
finishing=bind, Punch and single staple each document.
Stapling and punching requires that you specify output-bin=stacker-1 with a
print request. These options are not available in V1.1 or earlier releases.
C–42 Printer Data Sheets