Technical data

Setting Up and Maintaining Queues
14.6 Using Queue Options
Table 14–1 (Cont.) Qualifiers for Specifying Queue Options
Qualifier
Type of
Queue Description
For More
Information
/NAME_OF_
MANAGER
Batch
and
output
Specifies the name of the queue manager with which
the queue will be associated.
Section 13.8
/NO_INITIAL_FF Output Specifies the qualifier for an output execution queue;
suppresses the initial form feed sent to an output
execution queue.
Section 14.6.7.9
/ON Batch
and
output
Creates a nonautostart execution queue and specifies
the node (and, for output queues, the device) on which
the queue is to run.
Section 14.4.2.1
/OWNER_UIC Batch
and
output
Specifies the user identification code (UIC) for the
queue.
Section 14.6.1.2
/PROCESSOR Output Specifies the symbiont to be used with an output
execution queue. The default is the standard
operating system print symbiont PRTSMB.
Section 14.4.1
/PROTECTION Batch
and
output
Specifies a protection for the queue. Section 14.6.1.2
/RECORD_
BLOCKING
Output Determines whether the symbiont can concatenate (or
block together) output records for transmission to the
output device.
Section 14.4.1
/RETAIN Batch
and
output
Holds jobs in the queue after they have executed. Section 14.6.2
/SCHEDULE Output Specifies whether pending jobs in a queue are
scheduled based on the size of the job.
Section 14.6.5
/SEPARATE Output Specifies required job separation or job reset options
for an output execution queue. Required options
cannot be overridden by the PRINT command.
Possible options are as follows:
BURST Section 14.6.6
FLAG Section 14.6.6
RESET Section 14.6.8
TRAILER Section 14.6.6
/WSDEFAULT Batch
and
output
For batch queues, specifies a default working set
size for batch jobs executed in the queue. For output
queues, specifies a default working set size for the
symbiont process.
The value set by this qualifier overrides the value
defined in the UAF of any user submitting a job to the
queue.
Section 14.6.4
/WSEXTENT Batch
and
output
For batch queues, specifies the working set extent for
batch jobs executed in the queue. For output queues,
specifies a working set extent for the symbiont process.
The value set by this qualifier overrides the value
defined in the UAF of any user submitting a job to the
queue.
Section 14.6.4
(continued on next page)
14–22 Setting Up and Maintaining Queues