Technical data

Using BACKUP

11.19 Troubleshooting

4. Place a new tape into the drive and enter YES in response to the prompt for

a new tape.

5. BACKUP restarts the save operation from the beginning of VOL3; no data is

lost.

11.19.2 Tape Label Errors

When you instruct BACKUP to use a tape that has a label other than the one you

speciﬁed, BACKUP issues the following message:

%MOUNT-I-MOUNTED, DKA0 mounted on _SODAK$MUA0:

%BACKUP-W-MOUNTERR, volume 1 on _SODAK$MUA0 was not mounted because

its label does not match the one requested

%BACKUP-W-EXLABEER, volume label processing failed because

volume TAPE4 is out of order, Volume label TAPE1 was expected

specify option (QUIT, NEW tape, OVERWRITE tape, USE loaded tape)

BACKUP>

Depending on the option you specify, you can quit the backup operation (QUIT),

dismount the old tape and mount a new one (NEW), overwrite the data on the

tape (OVERWRITE), or USE the loaded tape.

If you use blank tapes or tapes that you intend to overwrite, use the

/IGNORE=LABEL_PROCESSING qualiﬁer. This suppresses the previous

BACKUP message, which normally occurs if BACKUP encounters a non-ANSI-

labeled tape during a save operation.

Using BACKUP 11–69