Specifications

Completing the Appliance Setup
42 Continuous Access Storage Appliance Installation and Maintenance Guide
Setting network properties
Before shipping the appliance, HP Manufacturing enters information for each appliance node
using the CASA setup utility window. This information enables the appliance nodes to
identify and communicate with each other. Table 4 lists the information entered for node 0;
Table 5 lists the information entered for node 1.
At the customer site, you must update the LAN Interface network information. If the customer
uses IP mirroring, you must also update the MirrorLink network information. You do not have
to change the InterLink information.
HP Manufacturing generates the serial ID, which has the following format:
■ CC—Country code
■ S—Site code
■ YY—Last two digits of the year (04, 05)
■ WW—Two digits representing the week (01–52)
■ XXX—Sequence number
The same serial ID is used for both appliance nodes.
Note: The previous serial ID format, which included the prefixes usra and usrb, will work in the
CASA setup utility window to accommodate older installations.
Table 4: Settings for node 0
Field Value
Peer Node General – Settings
Host name Node 0
Node id 0
Serial id CCSYYWWXXX
Peer IP address 10.0.1.2
LAN Interface
IP Address 10.100.70.130
Subnet Mask 255.255.255.0
Default Gateway 10.100.70.1
MirrorLink
IP Address 10.0.2.1
Subnet Mask 255.255.255.0
Default Gateway blank
InterLink
IP Address 10.0.1.1
Subnet Mask 255.255.255.0
Default Gateway blank