Specifications

Service Messages
160 Continuous Access Storage Appliance Installation and Maintenance Guide
Setting node logging levels
The health monitor issues SNMP requests to the ProLiant insight management agents installed
on the appliance nodes. The status information gathered by the health monitor displays in the
status info section of the hp OV CASA Console window (See Navigating the CASA console
on page 24 for more information.)
The health monitor uses a logger to assist with troubleshooting. You can modify the logging
levels using the logging_level parameter contained in the logger.config file. This
file is located in c:\shell\config folder. The default logging level is 2.
Table 10 lists the logging levels that you can set for the health monitor.
Table 10: Logging levels
Logging level Range Description
None 0..1 Generates the Logger started
and Logger stopped entries only.
Critical 2..4 Generates the least amount of log
entries.
High 5..7 Increases the number of log entries
generated, compared to the previous
level.
Medium 8..10 Increases the number of log entries
generated, compared to the previous
level.
Normal 11..13 Increases the number of log entries
generated, compared to the previous
level.
Low 14..16 Increases the number of log entries
generated, compared to the previous
level.
Debug 17.. Generates the maximum amount of
log entries for debugging.