Specifications

Replacing and Configuring Appliance Components
118 Continuous Access Storage Appliance Installation and Maintenance Guide
Reconfiguring the Gigabit Ethernet card
This section describes the procedures for:
■ Replacing the Gigabit Ethernet card
■ Reconfiguring the driver
The Gigabit Ethernet card replacement specifications as follows:
■ Part number—A7547-69001
■ Description—Dual–port Gigabit Ethernet Card
■ Assembly number—A7547-60001
Replacing the Gigabit Ethernet card
To replace the Gigabit Ethernet card:
1. Ensure that the hp OV CASA Console window is open in administrative mode.
2. Click service viewer.
The Services window opens.
3. Select the RPIC DPF service, set it to Manual, and then click Stop.
4. Repeat step 3 for the SMS service.
5. Close the Services window.
6. From the console window, click setup.
The CASA setup utility window opens.
7. Record the information that displays in this window.
8. Power down the appliance node with the defective card.
9. Disconnect the cables from the card.
10. Replace the defective card.
11. Connect the cables to the new card.
12. Power on the appliance node.
13. Ensure that the hp OV CASA Console window is open in administrative mode.
14. Click setup.
The CASA setup utility window opens.
15. Enter the network information you recorded in step 7 and click OK.
16. Click OK when the following message is displayed:
The operation completed successfully. Please reboot this
machine for the changes to take effect.
Note: Do not reboot the node at this time.
17. Click service viewer.
The Services window opens.
18. Select the RPIC DPF service and set it to Automatic.