Specifications

Replacing and Configuring Appliance Components
116 Continuous Access Storage Appliance Installation and Maintenance Guide
9. To select a parameter, highlight the parameter name and press Enter. Then specify the
value for the parameter listed below.
■ Execution Throttle—90*
■ Luns per Target—8
■ Enable LIP Rest—No
■ Enable LIP Full Login—Yes
■ Enable Target Reset—Yes*
■ Login Retry Count—60*
■ Port Down Retry—30*
■ Link Down Timeout—0
■ Extended Error Logging—Enabled*
■ RIO Operation Mode—5*
■ Interrupt Delay Timer—0
An asterisk (*) indicates that you must change the parameter to the value listed.
Parameters without an asterisk show the default value; do not change this value.
10. Press Esc to return to the Configuration Settings menu.
11. Press Esc again.
The Configuration settings modified menu opens.
12. Click Save changes and press Enter.
The Fast!UTIL Option menu opens.
13. To reconfigure another HBA, click Select Host Adapter and repeat steps 3 through 12.
14. From the Configuration Settings menu, click Raw Nvram Data.
The Raw Nvram Data window opens.
15. Verify the HBA type of each adapter. Check the value at the intersection of F0 and 0A.
The value for initiator HBAs is 77; the value for target HBAs is 28.
16. When you finished reconfiguring adapters, click Exit Fast!UTIL and press Enter.
The Exit Fast!UTIL menu opens.
17. Click Reboot System and press Enter.