Specifications

Replacing and Configuring Appliance Components
115Continuous Access Storage Appliance Installation and Maintenance Guide
Resetting the firmware parameters for an initiator HBA
To reset an initiator HBA’s firmware parameters:
Note: The firmware parameters for the target HBAs are set when the target driver loads during RPIC
DPF setup.
1. Reboot or turn on the appliance node.
2. When prompted, press Ctrl+Q.
The Select Host Adapter menu opens, listing the available HBAs in scan order.
3. Select the first adapter and press Enter.
The Fast!UTIL Options menu opens.
4. Click Configuration Settings and press Enter.
5. Click Host Adapter Settings and press Enter.
6. To select a parameter, highlight the parameter name and press Enter. Then specify the
value for the parameter listed below.
■ Host Adapter Bios—Disabled
■ Frame Size—2048
■ Loop Reset Delay—5
■ Adapter Hard Loop ID—Disabled
■ Hard Loop ID—0
■ Spin up Delay—Disabled
■ Connection Option—2
■ Fiber Channel Tape Support—Disabled*
■ Data Rate—2
An asterisk (*) indicates that you must change the parameter to the value listed.
Parameters without an asterisk show the default value; do not change this value.
7. Press Esc to return to the Configuration Settings menu
8. Click Advanced Adapter Settings and press Enter.