Specifications

7–128 CLI Commands
If you enable another host ID, previously enabled hosts are not disabled. The new ID
is added. If you wish to enable only certain IDs, disable all access paths
(DISABLE_ACCESS_PATH=ALL), then enable the desired IDs. The system will
display the following message:
Warning 1000: Access IDs in addition to the one(s) specified are still
enabled. If you wish to enable ONLY the id(s) listed, disable all
access paths (DISABLE_ACCESS_PATH=ALL), then enable the ones
previously listed.
MAXIMUM_CACHED_TRANSFER_SIZE=n
MAXIMUM_CACHED_TRANSFER_SIZE=32 (Default)
Sets the largest number of write blocks to be cached by the controller. The controller
does not cache any transfers over the set size. Accepted values are 1 through 1024.
The MAXIMUM_CACHED_TRANSFER_SIZE switch affects both read and write-
back cache when set on a controller that has read and write-back caching.
IDENTIFIER=n
NOIDENTIFIER
The IDENTIFIER switch is used with the SCSI_VERSION switch when the SCSI
version is set to SCSI-3 mode. The IDENTIFIER switch creates a unique unit
identifier makes the unit visible to the host. This number can be a value between
1–9999.
Identifier is an alternative way (other than worldwide name) for OpenVMS operating
systems to identify the unit.