Specifications

7–124 CLI Commands
SET remote-copy-set-name
IMPORTANT: This command works in a remote copy environment only using
HSG80 ACS V8.4P code, where local (initiator) and remote (target) sites coexist.
Changes the characteristics of a remote copy set.
Syntax
SET remote-copy-set-name
Parameters
remote-copy-set-name
Specifies the name of the remote copy set to modify. This is the name used with the
ADD REMOTE_COPY_SETS command to identify the remote copy set as a host-
addressable unit.
Switches
ADD=target path-name
Adds a controller pair into the remote copy environment. This command is most
useful when a failed controller pair has been repaired and must be added back into the
remote copy environment.
The target path-name consists of two parts: 1) the controller pair name specified with
the SET controller REMOTE_COPY= command and 2) the remote unit name, which
you create using the ADD REMOTE_COPY_SET command.
ERROR_MODE=FAILSAFE
ERROR_MODE=NORMAL (Default)
Select ERROR_MODE=FAILSAFE to lock in the remote copy set. This way, when
one controller pair fails, the unit in the other remote copy set cannot be overwritten.